Haven't really done much, still a novice but my first main project was to interface with an XBOX 360 and create a programmable stick. Got it working, got a few PCB's made up now I'm just soldering the components on and hopefully not frying them at the same time. My breadboard is still active, so worst case scenario is that I can go back to that to refine the design and so on.
Technically, I think that it could be done a whole lot easier, but at the moment it's just a couple of Shift Registers, and some transistors to create the button press closed circuits.
Haven't really done much, still a novice but my first main project was to interface with an XBOX 360 and create a programmable stick. Got it working, got a few PCB's made up now I'm just soldering the components on and hopefully not frying them at the same time. My breadboard is still active, so worst case scenario is that I can go back to that to refine the design and so on.
Technically, I think that it could be done a whole lot easier, but at the moment it's just a couple of Shift Registers, and some transistors to create the button press closed circuits.
Are those transistors connected to the buttons of an existing gamepad?
yeah to isolate the circuit created and to emulate a button push sent from the shift register.